EverGreen Scotts EasyGreen Rotary spreader, Grass and Lawn Seed Spreader, for easy application of lawn products and grass seed, 290.0 mm*600.0 mm*330.0 mm

Product Information

Walk steadily pushing the spreader while also squeezing the trigger on the handle. Release trigger at the end of each pass The spreader covers a width of 3m. The recommended walking speed is approximately 8.3m in 10 seconds. Because the outer edges of each strip receive slightly less granules than the centre, we recommend overlapping the strips by approximately 30cm (1ft). This will ensure even coverage to the whole area. For grass seed such as our Jubilee Premium Lawn Seed, use an initial rate setting of 30 and complete the calibration test to fine tune the setting. Due to the bulky nature of grass seed you may require 2 applications at this rate to apply the correct amount of seed. Please note – we do not recommend using this spreader for Shadesman Seed due to the small size of seed. Calculate the area of the lawn in square metres by multiplying the length by the width (1 large stride = approx 1 metre)

Scotts Rotary Lawn Seed Spreader - The Range Scotts Rotary Lawn Seed Spreader - The Range

Weigh out the required amount of fertiliser using scales and a jug as a container. For example, if your fertiliser recommends an application rate of 20g/m² and your test area is 10m², you will want to measure out 200g of fertiliser. For the purpose of the test, we would suggest doubling this amount, this will make it easier to work out if you are over applying. Make sure the spreader is closed in the off potion and pour in the measure fertiliser. Our delivery partners may vary delivery schedules at certain times of the year. ProGreen cannot be held liable for errors or delays caused by our delivery partners. Please ensure all the details you supply are complete and accurate to achieve the best delivery. For more information on how The Pallet Network delivers our different types of products, please watch this short video. What Issues Could Arise With Delivery? Mark out a test area. Ideally this area should be 10m². 1 large stride = approx 1 metre. Try and be as accurate as possible as this will affect the rate of application. If your initial rate was wrong, do the test with a higher or lower setting as required. Repeat this test until you achieve the correct rate and then make a note of this setting for future reference. Please note as each product will vary you will need to complete this test for each product you wish to use.

More Info

PLEASE NOTE: Turf, Wildflower Turf, Sedum Mats and bulk Bag products are delivered on a pallet and can only be delivered to the kerbside. Use a set of scales to weigh out the product and then add it to the spreader ready to apply – be accurate and do not be tempted to add a bit extra as this may cause scorching to your lawn.