youyeetoo NanoPi R5S Mini Router with Metal Case,4GB LPDDR4 16GB EMMC, RK3568 Development Board 0.8TOPS NPU Support Docker Three Ethernet Ports USB3.0 HDMI Support M.2 NVMe PD Power (Power Bundle)

Product Information

Fix the problem that in some cases hdmi has no signal output and needs to be plugged in once to recover The NanoPi R5S has rich hardware resources with a compact size of 90 x 62 mm. FriendlyElec has released a carefully-designed custom CNC housing for it. It has one HDMI port. It works with Android, Ubuntu Desktop and Buildroot etc and works with headless systems as well. It supports decoding 4K60p H.265/H.264 formatted videos. By default, the system will be booted from the TF card first, but this is not the case under all conditions. This section will explain all situations in detail; For official OS, you need select the file with the filename containing '-sd-', for example: rk3NNN-sd-friendlywrt-21.02-YYYYMMDD.img.gz, the compression file only supports the .gz format. If the file is too large, you can compress it into .gz format before uploading. After reading through the DietPi installation instructions, I get the impression the installation will instead remain on the SD card–is that right? Is there a reliable/recommended method of manually migrating the installation from the SD card over to the eMMC (or perhaps an SSD)?

If the system in the eMMC, or the system in the TF card uses the first Loader type U-Boot TPL/SPL, it will always boot from the eMMC; Buildroot is a simple, efficient and easy-to-use tool to generate embedded Linux systems through cross-compilation. It contains a boot-loader, kernel, rootfs, various libraries and utilities(e.g. qt, gstreamer, busybox etc). On the front side of the enclenclosure, four operation status LED lights, including for all three Ethernet ports. The NanoPi 5RS doesn’t have a power button, but there is a simple solution if you need one. You can buy a USB C Power On/Off Switch Cable to solve this problem. You can find a suitable cable in A+ Phone Accessory Store. HDMI Port If your main network is IPv4, and NanoPi-R5S works in IPv6, the computer may not be able to connect to the Internet. It is recommended to turn off IPv6 (the method is described later in this WiKi), or switch the main route to IPv6; The M.2 NVME interface is very accessible. To access the interface, you need to unscrew the four Philips cover screws and assemble the SSD Card, as shown in the photo below. Other Suggestions!

Distributed images are optimized for flash media (SD/eMMC/SSD) and compacted to real data size. Fast A little further down in the FriendlyElec wiki post ( here), after the image is installed to the eMMC, there is a firmware bundle that gets flashed to the drive as well. Is this firmware bundle included in the DietPi image, or otherwise not needed if using DietPi?

Insert the SD card into your computer, go to the SD card's OS-related directory, and edit the file parameter.txt, which is a text file containing command-line parameters， Go to "Network" -> "Firewall" and set "Inbound Data", "Outbound Data" and "Forwarding" in "WAN Zone" to "Accept";More than 1 physical network port, I know there is a USB to LAN, but I've had problems with such a card, on a RaspberyPi 4 FriendlyELEC NanoPi R5S single-board computer (SBC) measures 90 x 62mm, slightly larger than the Raspberry Pi 4 Model B, which measures 3.6 x 2.4 Inches (92x60mm).