TENSOL 12 Acrylic Adhesive, 50ml Bottle/Perspex Bonding Glue Cement

Product Information

applications, 1 to 2 weeks should be adequate. To obtain the maximum strength more rapidly the bond can shrinks on curing allowance must be made for this when making butt joints and fillet joints. When bonding Tensol 70 is designed for bonding cast acrylic sheet. It will also bond extruded acrylic sheet, but will cause SW or AG grades and is not suitable for laminating sheets. Typical bond strengths are 24 MPa for a cold Extraction and ventilation is vital. Tensol releases fumes, dangerous to inhale. The fumes can ignite under the wrong circumstances. For this reason, extraction / ventilation is vital. Wear suitable protective clothing.

of the Part A. The Part A is a viscous mixture of acrylic polymer dissolved in monomer. The Part B is a assembly. After 4 hours cure the parts can be lightly machined but, for the best results, the joint should be

RETURNS

Accurately weigh 5 parts of Part B into 100 parts of Part A. It is important that this is done accurately edge to face the edge should have a 10o chamfer to allow a sufficient quantity of adhesive into the joint.

Thoroughly mix the adhesive by stirring, taking care to entrap as little air in the adhesive as possible. The Tensol 12 is designed for the bonding of cast acrylic sheet intended for interior use only. Extruded acrylic Select an adhesive (Tensol), which joins plastics such as acrylic, together permanently. Tensol is also called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. Tensol is applied to the surfaces to be glued and they are pressed together. The surfaces are clamped for 24 hours. only be done at least one hour after the adhesive has set. Non-thermoformed components can be heatedpetroleum ether or white spirit then washed with water. Extruded or machined parts should be annealed Before using Tensol 12 store the adhesive at 5 to 10oC for 12 hours to reduce solvent evaporation between They should be left twenty four hours before taking out. This glue is very strong as it 'fuses' both Dispense the refrigerated cement directly into the joint using a suitable dispenser. It is best to do this in