16 Amp Double Pole Pull Switch With Neon

Product Information

To save a little time and fatigue, loosen the terminal screws on the new switch also. Step 4 – Connect New Switch

The neutral wire should also have a brown sheath or brown tape wrapped around it to indicate that it’s the switched live, but this will depend on the wiring setup. As long as you wire it up the same as the old switch, all will be well.

Again, if this has does not work, the whole unit must be replaced. Replacing the Cord From a Pull Cord Switch Pull the switch free and turn it over to access the wires. Take a picture of the wires (normally just 2), noting exactly which wire is in which terminal. Form a knot and then lower the finial to cover it. Other types of finial are available, such as timber or porcelain/ceramic, from hardware or DIY stores. In this DIY guide we look at how to install a pull cord switch. Regulations for Installing Pull Cord Switches

One thing to note however is that the switches do differ slightly. Whereas the 6 amp switch is single pole, the 45 amp switch will be double pole as it needs to be able to isolate both the live and neutral. To fit a pull cord switch or indeed just replace the cord, you will need the following tools and products. Step 1 – Before doing anything, turn off the circuit you are working on in the consumer unit or fuse box by turning off the MCB or pulling out the fuse. Most of these types of switch include a neon indicator, which will glow red or orange. If you have switched off the supply correctly the indicator will not be lit. Standard 6amp pull cord switch Tools and Materials Needed for Repairing and Replacing a Pull Cord Switch The very first job to do before anything is to ensure the electricity is isolated for the circuit you will be working on.

How to Replace a Pull Cord Switch

For the first part of this guide we will work through replacing a standard 6 amp pull cord light switch. From step 6 we will explain changing a 45 amp isolation switch. Step 1 – Isolate the Switch and Circuit