HB Body 222 Bumpersoft Car Body Filler Black Putty For Plastic Bumpers 250g With Hardener Excellent Adhesion Easy To Sand With P120-P240

Product Information

Rigid PVC strips are manufactured from a different material to our flexible plastic strips and we encourage you to request samples if you are unsure which material to choose. Immediately fold the sheet and shape adhesive with fingers. Force adhesive into the drilled holes. Do not press too hard to keep a 3 to 5 mm layer of adhesive material on both side of the tab. Also, curing epoxies are hydroscopic so the low temperature environment may well leave the resin vulnerable to absorbing moisture, especially if the environment is relatively damp or high in humidity as can be found in some outdoor workshops or home garages. Epoxy resins have very little odour and so it's quite viable to use them indoors (i.e. in your house) without upsetting anyone. The resin is almost completely odourless and the hardener has an amonia smell which doesn't really carry or linger. After 5 minutes shape tab using 3M™ Cubitron™ II Roloc™ Fibre Disc 80+ / 180+ and create a new fixing point to restore original appearance.

Thoroughly clean the bumper inside and out. Any dirt or grease will stop the filler bonding properly and ruin the appearance of the repair. Allow to dry and wipe down with solvent wipes, which are usually included in the kit. Whether you need to know how to patch a hole in plastic or join two pieces together, using the right adhesive is key. s plastic repair process allows you faster repairs by using the Instant Plastic Repair patch, cutting the time of the repair as you don't need to wait for two areas of adhesive to cure. To finish the repair and prepare for the primer, the use of a Plastic Filler Product is recommended. Once hardened, finish the sanding with wet fine grit sandpaper for a really smooth finish and wipe away any dust.Prepare surfaces. Surfaces should be close fitting (pre-fit before joining), free of residue, and dry. Slightly roughen smooth surfaces to improve results. Stay safe. Work in a well-ventilated, protected area. Wash your hands when you are finished, and optionally wear gloves for extra protection. It depends on whether you choose rigid plastic strips or flexible plastic strips as to how bendable the plastic strip will be.

Our plastic strips are manufactured from uPVC although it is important to point out the difference between the plastic material we use and the plastic material used by the double-glazing and widow industries. In those industries, additional stabilisers are often added to the uPVC, whereas our material is standard uPVC. Can be used from 15 to 30°C although pot-life and cure time will be affected significantly. Recommended working at an ambient of 20-25°C. Drill several holes of 3-6 mm in diameter in the remaining part of the tab to increase the strength of the repair. Using a 3M™ Cubitron™ II Clean Sanding Abrasive Disc 180+, sand the area to shape, ready for either an application of plastic filler or prepare directly for primer application.To finish the plastic bumper repair and prepare for the primer, the use of a plastic filler product is recommended. Use either 3M™ Flexible Plastic Filler for plastic-like performance and excellent sanding and feather-edging, or use 3M™ Plastic Filler. Clean the area inside and outside using 3M™ VHB™ Surface Cleaner or 3M™ General purpose Adhesive Cleaner applied with a 3M™ Professional Panel Wipe.