Alfa Network AWUS036NHA – USB WiFi Adapter, 150 Mbps, 802.11b/g/n, RP-SMA, AR9271L Atheros Chipset

Product Information

iwconfig wlan(x) txpower 30 - This is the command that sets txpower and 30 is the highest you'll get I connected both the H and the HA to an Engenius AP so I could monitor the signal level of both devices. This AP is about ¾ mile from me, and I am using just the standard 5db rubber antenna’s that ship with each unit. type ~/wifichanges/wireless-regdb-2013.02.13#leafpad '/root/wifichanges/wireless-regdb-2013.02.13/db.txt'

ALFA AWUS036NHA with the Atheros AR9271 How to install ALFA AWUS036NHA with the Atheros AR9271

This is a single band (2.4 GHz) 802.11n adapter with maximum transfer speeds of 150 megabits per second (mbps). This is for one brand new (in retail box) AWUS036NHA wireless adapter with USB cable 5 dBi gain antenna, and installation CD. Some ALFA models include a bonus mount accessory, this one does not. Note since this is my only wifi adapter i went ahead and deleted my original crda folder you dont have to do this step if you already have a crda folder but it helped when i deleted mines.Finally, I ran Wash to find out if there were any weak WPS devices that I could use to test out my new card. root@kali: ~# wash -i wlan0mon I’m running into the same issue that James posted on November 15th. When I disconnect and reconnect the device manually then go to Devices>USB>Atheros, just as you suggested to James, I still receive the “failed to attach the USB device” warning.

Alfa AWUS036NHA - Wireless B/G/N USB Adaptor - 802.11n Alfa AWUS036NHA - Wireless B/G/N USB Adaptor - 802.11n

So now when i run ifconfig I get that wlan0 is up (Alfa) but eth0 is down (Intel(R) Wireless-N 7260). I’m new to penetration testing and have recently been taking online course, however I installed Kali Linux on windows 10 recently which all went fine. The issue i have is when I try using the the alpha AWUS036NHA wireless adapter . I works fine on the host machine however it isn’t passing through to kali linux. A lot of the times the adapter just cuts off when I start Kali and when I boot up Kali and then connect the adapter it dosent switch on as it should. I’ve tried your steps above however with no success. Also I’ve noticed that the usb icon at the bottom right of the screen is showing no activity i.e red or green blinking dots and it states ‘No USB Devices Attached’. I’ve tried the method above several times on different ports also with no success. I’ve ran the following commands on the Kali terminal Sometimes retailers have a tendency to promote a specific attribute of a product as if it is the only thing that matters. In fact, while higher output is a good thing, it is not the only thing that determines your range and signal strength.wifichanges/wireless-regdb-2013.02.13#make what we want to do here is after the folder is cd just type make A must have for every laptop user because this is 10 times more poweful than your laptop built in wifi and it give your laptop a better wifi reception and respone for faster internet ascess After I had the device filter setup, I detached the device from my workstation and logged into Kali. As you can see, there are no wireless devices connected to my VM yet. Since AWUS036NHA supports injections, make sure you are more close (use a better antenna ) usb 2-2: ath9k_htc: USB layer deinitialized apt remove firmware-atheros