Joined in 2023 
82 
63 About this deal
It is possible to achieve a more balanced wear behaviour due to the introduced model for load-adjusted grinding wheel design. The previously spaced courses of Q' w are then nearly congruent. It is possible to make this adjustment because a higher initial value of Q' w increases the overall amount of wear but does not affect its progression across the grinding wheel width. This allows the development of a graded grinding tool which can be used for all investigated end mill cutter geometries at the same time if the condition of congruence of the curves is fulfilled. The increased amount of wear at a higher depth of cut can be counteracted by adapting the feed rate. Lu YJ, Li LJ, Xie J, et al (2017) Dry electrical discharge dressing and truing of diamond grinding wheel V-tip for micro-grinding. In: 2017 5th International conference on mechatronics, materials, chemistry and computer engineering (ICMMCCE 2017). Atlantis Press, pp 548–552
Edge Diamond Grinding Wheel – Giant Nebula
The union of the diamond particles to the body of the grinding wheel is carried out by means of the vacuum brazing technique, which guarantees a high resistance to friction and temperature. Zheng G, Lin Y (2021) Tribological properties of micro-groove cemented carbide by laser processing. Micromachines 12:486 Denkena B, Böß V (2009) Technological NC simulation for grinding and cutting processes using CutS. In: Proceedings of the 12th CIRP conference on modelling of machining operations In particular, the thermal load often defines the process limits in flute grinding and can thus be associated with the strong increase in wear in the area of a high depth of cut [ 16]. A purely experimental approach can iteratively lower the wear in these areas by increasing the grain concentration, as shown in the results of the ungraded grinding wheels, too. Apart from this, it also shows that a reduction of the wear difference is possible by adjusting the area-related number of grains to the local related material removal rate according to formula 4. Jin T, Stephenson DJ (2006) Heat flux distributions and convective heat transfer in deep grinding. Int J Mach Tools Manuf 46(14):1862–1868RUBI PRO-EDGER diamond grinding wheels allow beveling, blunt edge, and 45º mitering on any type of ceramic tile, as well as on natural stone (marble, granite, etc.) and sintered stone.
PRO-EDGER diamond grinding wheels | RUBI UK
Wang Y, Zhou X, Hu D (2006) An experimental investigation of dry-electrical discharge assisted truing and dressing of metal bonded diamond wheel. Int J Mach Tools Manuf 46:333–342 Due to smaller grain sizes in the area of the grinding wheel edge, the cutting edge roughness could be reduced. Wang X, Ying B, Liu W (1996) EDM dressing of fine grain super abrasive grinding wheel. J Mater Process Technol 62:299–302 Zhang FH, Kang GW, Yang YS et al (2006) EDM dressing for metal-bond super hard arc-forming wheel. In: Key Engineering Materials. Trans Tech Publ, pp 99–103
Ceramic tile or stone finishes, whether natural or sintered, are the culmination and most visible part of any cladding job. RUBI PRO-EDGER diamond grinding wheels offer excellent results on any ceramic tile format. Grain concentration and grain size directly influence the occurring wear during deep grinding. The results show that there is a maximum (percolation threshold) in grain concentration due to structural bonding failure.
Great Deal 
New Comment