SANSUN 2.4W LED MR11 Light Bulbs, Replacement for 12V 20W 35mm Halogens, Fiber Optics Christmas Tree Bulb, G4/GU4/GZ4 Bi-Pin Base, Soft White 3000K, (Pack of 4)

Product Information

I currently have down lights with Osram decode 51s (12V 50W) halogen bulbs. Each light has a dimmable 60VA transformer connected. Could you please advise on a suitable replacement dimmable LED bulb?

The LED bulbs I bought seem as though they will be fine in my current MR16 housings. The existing lights are running through a Low voltage dimmer. i’ve tried replacing my warm led spotlights with brighter led spotlights but they flash on and then go super dim. Can you help explain why that might be?

Heading 2

The G4 Bayonet Light is non dimmable and has a 2.5 watt light bulb. A warm white (3000K) light is very similar to a normal 20W halogen bulb and can be sufficiently bright. Can I replace gu5 3 halogen with LED? You would need a transformer to reduce the mains voltage down to 12 volts. There are two types of transformers available in the market. One is the electromagnetic transformer and the other is electronic. Electronic transformers are preferred due to their efficiency and low cost. #3 The compatibility So i have removed 50W halogens and replaced them with 5W LEDS which are equivalent to 50W halogens. They work fine but i am worried it will cause a fire so thats why I have asked.

When replacing Halogen MR16 light bulbs with LED bulbs, it’s important to use LED bulbs of equivalent wattage to your existing halogen light bulbs. This will ensure that the transformer can still handle the load safely.The volt-ampere (VA) rating is the maximum load (in watts) that a transformer can safely carry. For example, a 40VA transformer can handle up to 40-watts of electrical equipment, while a 10-60VA one can carry between 10 and 60 watts worth. Installing low voltage LED light bulbs on a transformer designed for halogen lighting requires you to find the equivalent wattage ( see above) for the LED bulbs, so as not to overload the transformer. Fortunately, upgrading Halogen MR16 light bulbs to LED is usually a painless affair, as most LED light bulbs are now designed to retrofit to existing light fittings. All you have to do to swap your old bulbs out is remove them from the light fixture and fit the new, shiny bulbs in their place. I have 6 downlight fittings in my lounge on a single dimmer switch. I want to replace the current lamps for LED version. The info. on the bulb is LCLEXNE MR16+C 12v 50w 1045. There are light emitting devices you can use in your fixture. The equivalent of a 50 watt bulb will burn between six and seven watt. Can I replace 2 pin halogen bulb with LED?